Lacie 5bign_v2 support

[Draftmancorp]

:dry yes i've upload.....i just thought that i have to sobstitute "fvdw-sl-installer" with "UIMAGE-26394-NWSP2CL-106" don't know why..... :hail bo...this my fault.


now.....at:
/fvdw-sl-installer ip-pc (ip of my nas) 192.168.1.252
have this:

step 1: check to make sure all dependencies are present on the server and nas:
Dialog: tftp: timeout
There was an error installing dialog! Installer cannot start!
root@(none):/ #

[Draftmancorp]

i'll go crazy, every time i have to repeat all from begin :mrgreen:

[fvdw]

it is clearly not our night, you should have that in your tftp directory, and you should not close the tftp server (start it again if it is closed)

tftp-1.JPG

[Draftmancorp]

all it's the same, and the server isn't closed.............i try again but i think will be the same.

[fvdw]

well it worked last week....see prove here http://forum.nas-central.org/viewtopic. ... &start=255

[Draftmancorp]

yes but THERE in the ultimate installer line is write....ip of my pc.....here is write ip of my NAS.... :scratch

[fvdw]

the instruction clearly mention use ip of your pc :laughat (so not your nas)
This

(10)start the installer by entering:

Code: Select all

/fvdw-sl-installer ip-pc

(replace ip-pc by ip address of your pc

[Draftmancorp]

you should use this in the the telnet client
(I assume you succesfully uploaded the scrip with tftp)

Code: Select all

/fvdw-sl-installer ip-pc

(replace ip-pc by the actual ip of your nas)

:whistle

[Draftmancorp]

That was the problem, now it si at 70% :) (I'm whit my tablet).......OK i'm sorry, I'm post a few.....

What i nave to do after 100%? :scratch

Edit:
Writing inode: 7000/14880

[Draftmancorp]

This, right?

ok I understand.
--edit fault in filename taken out

Then after firmware installation script is completed enter in the telnet client

Code: Select all

tftp -r UIMAGE-26394-NWSP2CL-106 -l UIMAGE-26394-NWSP2CL-106 -g ip-pc

replace ip-pc by actual ip address of your nas
Then write it to sda6

Code: Select all

 dd if=UIMAGE-26394-NWSP2CL-106 of=/dev/sda6

If thats done reboot

Code: Select all

reboot -f

and see if you can access the nas with fvdw-sl webinterface