Can’t boot after installation

[fvdw]

The bootloader is not the problem I think. It works or works not. Same with software. If it is corrupt it always fails at same point in the code.
If it sometimes works and sometimes not points to a hardware issue. It could be that your power supply is not stable or lacking sufficient power preventing the disk(s) from spinning up. In that case the bootlaoder gives up after some time because it doesn't find a working disk. On nwsp2 you get in that case the red flashing led.
It can also be a capacitors on the mainboard going bad preventing that sata inerface comes up.

Because of the red led behavior I would first try in your case if another power supply solves the problem. Changing capacitors on the mainboard is not so easy..
But please note that I am guessing here on what could be the problem, I can be completely wrong

[Redleh]

Hi!

I saw some people with 5big, with similar issue.
The disk starts spinning, but a few seconds after the nas shutdowns.
It’s not easy to turn the nas on, I will say like 1 in 20 boots is success.
I’m going to start with power supply.

But please note that I am guessing here on what could be the problem, I can be completely wron

My dear friend, all the help is welcome! :hail