Is there any way to restore an working uboot and how to do that via serial ? Any help would be appreciated ...
Thanks
- Code: Select all
_ ____ _
| | __ _ / ___(_) ___
| | / _` | | | |/ _ \
| |___ (_| | |___| | __/
|_____\__,_|\____|_|\___|
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__| fvdw vs80
** LOADER **
** MARVELL BOARD: ASTON_NS LE
Hold rear button - long :
U-Boot 1.1.4 (Jan 7 2013 - 21:15:04) Marvell version: 3.4.16 LaCie 1.3.9 256MB fvdw gpt usbboot vs80
U-Boot code: 00600000 -> 006701D0 BSS: -> 006BDAE0
Soc: MV88F6192 Rev 3 (DDR2)
CPU running @ 800Mhz L2 running @ 400Mhz
SysClock = 200Mhz , TClock = 166Mhz
DRAM CAS Latency = 3 tRP = 3 tRAS = 9 tRCD=3
DRAM CS[0] base 0x00000000 size 256MB
DRAM Total size 256MB 16bit width
[512kB@f8000000] Flash: 512 kB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
CPU : Marvell Feroceon (Rev 1)
.
Un-Protected 1 sectors
Erasing Flash...
.
Erased 1 sectors
Writing to Flash... done
.
Protected 1 sectors
Streaming disabled
Write allocate disabled
USB 0: host mode
PEX 0: interface detected no Link.
Net: egiga0 [PRIME]
egiga0 no link
Waiting for LUMP (3)
Abort
no lump receive; continuing
egiga0 no link
Waiting for LUMP (0)
no lump receive; continuing
Marvell>> <INTERRUPT>
Marvell>> version
U-Boot 1.1.4 (Jan 7 2013 - 21:15:04) Marvell version: 3.4.16 LaCie 1.3.9 256MB fvdw gpt usbboot vs80