How sad, the HDD in my Networkspace2 died, after about 5 years active service. It is clicking for about 30 seconds, an than it stops totally. The NWSP2 is blinking blue-red (never saw this before ;) ).
Some questions for this forum.
a) does anybody know a trick so I can read (and copy) my old HDD
b) If I buy a new HDD, how can I install it in my Lacie-case, and how can I place the FVDW firmware on it?
c) I experimented with the Plex-mediaserver on my Lacie. Actually the Lacie was too slow for Plex, in my opinion. Is there a better hardware where I can use the (my favorite) FVDW firmware, and where Plex will run more smoothly on it?
TIA
JDZ01