Cloudbox slow performance v 16.0

[Alfa809]

Code: Select all

root@Pandora:/ # ethtool eth0
Settings for eth0:
        Supported ports: [ TP AUI BNC MII FIBRE ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Advertised pause frame use: No
        Advertised auto-negotiation: Yes
        Link partner advertised link modes:  10baseT/Half 10baseT/Full
                                             100baseT/Half 100baseT/Full
                                             1000baseT/Half 1000baseT/Full
        Link partner advertised pause frame use: Symmetric Receive-only
        Link partner advertised auto-negotiation: Yes
        Speed: 1000Mb/s
        Duplex: Full
        Port: MII
        PHYAD: 0
        Transceiver: external
        Auto-negotiation: on
        Supports Wake-on: d
        Wake-on: d
        Link detected: yes


[fvdw]

Look ok and normal. Than I afraid I don't know what the cause could be of the too low read speed. With these settings I and many others achieve much higher speeds on a gigabit network. As it is only read that seems to be affected you would think on anetwork issue. But you also tried direct connection. Did you also try another cable? Gigabit uses 2 tx lines afaik if one of them doesn't work you drop back to a 10 mbits speed which is what seems to happen on your cloudbox

There are many more commands in ethtool to investigate the network traffic. Use the help option to list them all

[Alfa809]

Yes tried other cat 6 cable, and tested and cert cable.
Is possible to try to "factory reset" with this firmware without lose my share data?
Thanks

[fvdw]

Our firmware has a reset possibility. If you install the firmware again you get a clean system while your settings and shared folders are preserved. One setting will be reset with a new firmware install, that is the password for ssh access, that will be set to the default value (giveit2me).

[Alfa809]

I've an incredible news for you.
From a private share it have slow performance... in a public share (user dummy) have 48 mb/s.
So i don't know what is the problem.
from ls -l the permission are the same and same user/group.