LACIE D2 Network 2 Project (2)

[musafirrlail]

I have been till this step .. What this is right step ? So am so that read the fvdw instruction but are still not understand :doh

http://i61.tinypic.com/28sdab.png

[musafirrlail]

I tried till it is step, When try connecting to D2N2 from windows show warning, I dont know what the mean and what I can to do ..

http://i59.tinypic.com/2ev7ya8.png

[musafirrlail]

I tried repeat more then once step but progress just stuck at clunc-open -i 10.57.78.81 waiting for u-boot with position my D2N2 still alive ..

http://i62.tinypic.com/rhtkdi.png

:hail

[Jocko]

Hello

I found this from any thread, Can I asking ?

Are you know this feature for what ? What for create custom firmware ?

I mean at below here :

fvdw-sl/home.php

This is a feature to discover the firmware without installing it (it is a fake web interface)

[Jocko]

What do you after getting the clunc-open window (http://i62.tinypic.com/rhtkdi.png)
Note: at this step the NAS must be off and I assume that you try to start your NAS

(3) Start your NAS as soon as a window pops up with the remark that it waits for u-boot.
When the NAS is starting it will be detected by the program and it will interrupt the boot, you will see two red flashes of the led's of the lacie nas indicating this.
After that it will transfer the kernel to the NAS and tries to load and start it.

[musafirrlail]

At the time look like in the picture link below what should I do? Do let location in the tftp or change to nwsp2 you are looking at the previous post?

http://i57.tinypic.com/28wpbls.png

[Jocko]

If I remember the standalone UIMAGE file is in the folder tftp, so no need to change previously the folder used by tftpd.

But if it is in the subfolder nwsp2
You have two choices :
-keep the default tftp folder and at the step 2, browse in the folder tree to select the UIMAGE file in the subfolder nwsp2
-select the folder nwsp2 before using the feature 'install fvwd-sl firmware'. In this case tftpd will search only in the folder nwsp2

[musafirrlail]

Can I confirm one thing to you:

The first time I tried to use the application fvdw-sl-console with step (3) runs fine just the process connected telnet client always fails and I try to reconnect the results remain disconnected, and I repeat these steps for some reason now I D2N2 device is not detected at the time of waiting for u-boot, Do you know this constraint?

Is there any indication at the beginning of the process occurs not responding to my laptop so I close all applications fvdw-sl-console on my laptop following the deadly D2N2 from the back button ..

[Jocko]

I tried to use the application fvdw-sl-console with step (3) runs fine just the process connected telnet client always fails

Often that means that tftpd failed to send the standalone kernel and so no telnet server is available.

As you don't use a basic LAN network (192.168.x) may be there is an issue with your LAN settings and fvdw-sl console. Need to talk with fvdw about this point.

For the other point, see if there are some zombie process in the windows task manager.

[musafirrlail]

I am not using the default ip 192.168.XX, what if I use direct way between D2N2 to NIC laptop so the I can setup LAN IP with static between 2 device ? What do you think?