Following the instructions the tftp log reports that UIMAGE-395-NWSP2CL-199 has been sent to my cloudbox but I can't telnet in, firewall is disabled.
Set-up
Cloudbox set to 192.168.0.252 via LaCie web interface and then disk replaced with fresh solid state drive.
thanks!
plugout.net
Alternative firmware fvdw-sl
SPD8020, Lacie network space vs1,vs2 and max, 5big version 1&2, 2big version 1&2, internet space vs1, edmini_v2, D2 network version 1&2, raspberry Pi b
UIMAGE loads but telnet times out
3 posts
• Page 1 of 1
UIMAGE loads but telnet times out
by scottj » Wed Apr 23, 2014 3:55 pm
- scottj
- Posts: 2
- Joined: Fri Apr 18, 2014 1:54 pm
Re: UIMAGE loads but telnet times out
by fvdw » Wed Apr 23, 2014 8:06 pm
telnet only works with the standalone kernel not kernel 199
If you want to connect to the nas after installing and running the firmware you need to use a ssh client
If you want to connect to the nas after installing and running the firmware you need to use a ssh client
- fvdw
- Site Admin - expert
- Posts: 13472
- Joined: Tue Apr 12, 2011 2:30 pm
- Location: Netherlands
Re: UIMAGE loads but telnet times out
by scottj » Thu Apr 24, 2014 1:08 pm
oops, my bad. Installation was successful - thanks for great firmware!
- scottj
- Posts: 2
- Joined: Fri Apr 18, 2014 1:54 pm
3 posts
• Page 1 of 1
Return to Lacie cloudbox (white casing)
Who is online
Users browsing this forum: Bing Bot and 12 guests