How to use cloudbox after data recovery

[psa55]

I had a problem similar to the one described in viewtopic.php?f=28&t=2499
I managed to recover all data in the disk by using the procedure described in the post (copying data via ftp).
Thank you very much for the helpful info :thumbup

Could you please tell me if it is possible to use the cloudbox again or if I have to substitute it?

Thank you again.

P.S.
I am using a cloudbox with the original firmware with and 4TB disk.

[fvdw]

Depends whats wrong with your cloudbox. But if you were able to use our standalone kernel and copy the dat from the disk, it seems the hardware is ok.

[psa55]

Yes the disk should be ok, since I was able to use the standalone kernel and copy all data.
It seems the problem is with the cloudbox firmware.

When I try to connect I see the blu light blinking (slowly) for a long time. After sometime the light becomes red (fixed).

I also tried to use the u-boot command window with the following commands

setenv root_part 5
ide reset
setenv image /boot/uImage
run nexus_load_image
run nexus_bootargs
bootm

as you suggested in the other thread. After 24 hours the blu light was still blinking, so that I though it was not successfull.

At this point I can also format the disk, if needed, since all data were saved.
Can you give me any suggestion how I can proceed?

Thank you.