Not able to telnet into nas

[Jocko]

I would like to see what is the current content of sda5 and you did not post all asked outputs.

So get again a telnet access (but do not try to intall again the firmware) and post the output of

Code: Select all

mkdir /sda5
mount /dev/sda5 /sda5
ls -al /sda5

Do also these manual commands to see what happens

Code: Select all

busybox tftp -r firmware/NAME -l NAME -g 192.168.1.108
cat NAME
firmware=$(cat NAME)
busybox tftp -r firmware/$firmware.tar.gz -l /sda5/$firmware.tar.gz -g 192.168.1.108

[Doppie]

Hi Jocko, I did the whole exercise again. I started XP from Virtualbox on my Windows 10 pc. Then I downloaded the rar files and extracted them. Then I started the console and used the kirkwood-standalone image. Everything went smooth and now I have access to the nas. So at first I choose the wrong image and then I had corrupted the files )-; . Thank you for your patience with me.

[Jocko]

Hi Doppie,

if that worked with XP on the virtualbox that would mean win10 firewall blocked some sockets to upload the firmware files.

[Doppie]

I think that extracting the rar files went wrong under windows 10. I may have ignored an error after not properly downloading the files being impatience.

[ketchoupi]

hello

i've a question

i'm trying to install with uimage-3142-kirkwood-150-standalone under networkspace 2 with windows 10 on new disk (format fat 32)

is it very long ?
because i've telnet window : waiting for u-boot since about 20 minutes.

led ethernet blinking on networkspace 2

thanks

[fvdw]

No it should load in 15 seconds. If telnet client times out the you may have your firewall blocking the programs the console uses, or you are using a wireless connection between your pc and lan, or you have more then 1 network interface a ctive on your pc, disable all but one

[ketchoupi]

thanks for your answer
i've assigned a fix ip by mac adress and
i've forgotten to reboot my nas, and my disk is down. so anyway.

now, i know how to do it..... to buy another hard disk ....

see you