plugout.net

i was upgrade fvdw10.0, and start transmission, add some torrents..
but restart itself everytime.. i'm using transmission remote gui, torrents download begin, downloading couple minutes and disconnect deamon,
check web interface, but stopped transmission.. sorry for bad english :)

anyone else seeing the same problem ? on my system the daemon downloaded several files without issuesand without restarting

Following your post I did yesterday some download tests with the new version.

I have no problem : stop and start the transmission daemon; pause and resume torrent.

Amazing that you have problems. Can you more accurately describe your problem

no problem, i will watch my daemon and device .
and i will write more information in here..
thank you for quick reply.

Same PROBLEM here. Transmission stops itself after a certain time. Not depending if you leech one or more files.

Error:
Connection Failed
Could not connect to the server. You may need to reload the page to reconnect.

wd9895 wrote:Same PROBLEM here. Transmission stops itself after a certain time. Not depending if you leech one or more files.

Error:
Connection Failed
Could not connect to the server. You may need to reload the page to reconnect.

does transmission really stops or only the connection to the (transmission) web interface.

if this is a persistent problem we will need roll back to previous version

With my nwsp2, Transmission never stopped itself after 24 hours (with several leech files) :!:

after my reply, upgrade to the firmware fv10 (again, for test issue)

for this problem, please follow these steps..

1. start daemon
2. load web interface
3. add 2 or 3 torrent file..
for example: my torrents

Conan The Barbarian 2011 720p BRRip x264 AAC-ViSiON
Conan The Barbarian 2011 BDRip XVID AC3 HQ Hive-CM8

4. transmission is connect seeders, start downloading for couple minutes, after then
display connection failed message box..
5. start daemon again from web interface..
6 goto step 4 :)

i was rollback to 9.0, no problem, 24+ hours run silently.. :)

Well,

I did also a test with a nwsp vs1 which have a ressource size identical as SPD 8020.
No problem after one day...

Do you set speed limits (upload and download) : for nwsp1, I set 70kb for download and 10kb for upload?

Note : with the version 10, no limits is set by default whereas in the version 9, a speed limit is defined.

In my case everything is default :(
It's no matter if I run transmission in frame-mode under webinterface of the SPD8020 or in a dedicated browser window.

Of course the internet link is available. Just the torrent session dies.