plugout.net

Hello,

I'm trying to install the firwmare on my Lacie Wireless Space 2, I followed the instructions in this topic https://plugout.net/viewtopic.php?f=7&t=2313&p=20693#p20693 as the firmware files are not available I used the latest one. Installation seems to go fine. Once all is done, I cannot access the web page and cannot ping the nas.

Can someone please help me?
Thanks a lot
Math

did you adapt the bootloader?

Yes, I used UIMAGE-3142-KIRKWOOD-171-standalone for the install, once it was done I have changed uboot with

Code: Select all

setenv LaBackdoor yes
setenv bootcmd 'disk 0x800000 0:6 ; setenv bootargs console=ttyS0,115200 root=/dev/sda7 ; bootm 0x800000;'
saveenv

After that it does not seem to work as I cannot access the admin page, it does not seems to have an IP address.

ok which firmware version did you install?

Do you have a dhcp server in your Lan? and what is the ip pool it uses?

yes one disk of 2To

I have changed my last post as I mix up de wireless space with nwsp2 max. Indeed wireless space has only one disk.
Be sure to use alwasy lan1 connection

I have DHCP on my lan IP 192.168.1.1 - 192.168.1.200
I'm trying to install firmware 18-3.

Yes, I'm only using LAN1

In addition to the questions in previous post we can check if the wsp2 has successfully booted
To do that load the standalone kernel and and at the command prompt give these commands

Code: Select all

mkdir /sda7
mount /dev/sda7 /sda7
cd /sda7
cat boot.log

post the output of the cat command here

I tried that and output is : cat: can't open 'boot.log': No such file or directory

and what does the command

Code: Select all

dir /sda7

give as output