External Drive plugged into back of 2Big VS1 & fvdw-sl 18.2
Posted: Sat Jun 06, 2020 2:17 pmHi,
I have the 2Big VS1 running fine with 18.2 on SMB2/3 with internal SSD / RAID1.
I've also got a Toshiba 4TB Canvio USB External drive (powered by its own PSU) that I want to share on the network over the 2Big V1.
I plugged the Canvio into one of the USB ports on the back of the 2Big V1 and it is recognised under Attached Devices / USB-devices.
T: Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 3 Spd=480 MxCh= 0
D: Ver= 2.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=64 #Cfgs= 1
P: Vendor=0480 ProdID=d011 Rev=03.16
S: Manufacturer=TOSHIBA
S: Product=External USB 3.0
S: SerialNumber=20150124011162
C: #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr=2mA
I: If#= 0 Alt= 0 #EPs= 2 Cls=08(stor.) Sub=06 Prot=50 Driver=usb-storage
It isn't listed though under External Disks (it's already formatted with ext4 before) under Disk Setup / External Disks.
Am I missing a step?
TIA
Richard
I have the 2Big VS1 running fine with 18.2 on SMB2/3 with internal SSD / RAID1.
I've also got a Toshiba 4TB Canvio USB External drive (powered by its own PSU) that I want to share on the network over the 2Big V1.
I plugged the Canvio into one of the USB ports on the back of the 2Big V1 and it is recognised under Attached Devices / USB-devices.
T: Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 3 Spd=480 MxCh= 0
D: Ver= 2.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=64 #Cfgs= 1
P: Vendor=0480 ProdID=d011 Rev=03.16
S: Manufacturer=TOSHIBA
S: Product=External USB 3.0
S: SerialNumber=20150124011162
C: #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr=2mA
I: If#= 0 Alt= 0 #EPs= 2 Cls=08(stor.) Sub=06 Prot=50 Driver=usb-storage
It isn't listed though under External Disks (it's already formatted with ext4 before) under Disk Setup / External Disks.
Am I missing a step?
TIA
Richard