plugout.net

Hi All, New to the group and I'm looking for the download for fvdw-ls console.
I have a Lacie 2big Network V2 which I want to use to store my Plex media, but evidently I need smb 2 or 3 and the Lacie firmware only offers smb 1 .
Where do I find the console download?
Thanks in advance.
Cheers Mark
:please

look in the download subforum https://plugout.net/viewtopic.php?f=7&t=3767

Thank you. I have downloaded the files and will follow the guides.
If it works I'll happily send you a donation.
:-D

Hi there again.
I have downloaded the fvdw-SL console 6 and have followed all the instructions.
It seems to complete each time but when i boot up the nas it isn't found on the network.
i think it is failing with the partitions.
i wiped all the partions in the end but end up with the same result.
i am using UIMAGE-3142-KIRKWOOD-171-standalone

my nas is a 2Big Network 2 i adapted the uboot command

setenv LaBackdoor yes
setenv bootcmd 'disk 0x800000 0:6 ; setenv bootargs console=ttyS0,115200 netconsole=6666@${ipaddr}/,6666@${serverip}/ root=/dev/sda7 ; bootm 0x800000;'
saveenv


this didn't work either.

What would you suggest now?

when i ran fdisk to check partitions i got: see below.

i feel i am close but missing something. :)


root@fvdw-sta-kirkwood:/ # fdisk -l

Disk /dev/mtdblock0: 0 MB, 512000 bytes
255 heads, 63 sectors/track, 0 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

Disk /dev/mtdblock0 doesn't contain a valid partition table

Disk /dev/mtdblock1: 0 MB, 4096 bytes
255 heads, 63 sectors/track, 0 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

Disk /dev/mtdblock1 doesn't contain a valid partition table

Disk /dev/sdb: 1500.3 GB, 1500301910016 bytes
255 heads, 63 sectors/track, 182401 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

Device Boot Start End Blocks Id System
/dev/sdb1 1 182401 1465134080 7 HPFS/NTFS
root@fvdw-sta-kirkwood:/ #

seems you have a 2bignas (with 2 disks). Put the disk with the firmware in the other slot, as it is now seen as sdb and it should be sda.

Hi FVDW
After lots of tries installing fvwd-ls i decided to wipe both disks and reset via Lacie instructions, hold front button whilst switching on and holding it until light turns RED and then release, and press again when light is solid BLUE. This seemed to work and i expected to see Lacie firmware loaded but it appears it has now loaded the FVDW-LS firmware.....which is great.
I seem to be upload via FTP at around 15Mb/Sec is this about right or should it be faster?
I will probably donate if it continues working, what extra's do i get once I've donated?

Thanks for your help
Cheers Mark