Hi,
I am unable to connect to my 5big2 from network (http and clunc). The Front blue LED is always blinking. So I would like to display the startup message from its serial port. I bought a cable but I don't know where are the TX, RX and GRND.
Do you know the pinout of the J2 connector?
Thank you very much.
plugout.net
Alternative firmware fvdw-sl
SPD8020, Lacie network space vs1,vs2 and max, 5big version 1&2, 2big version 1&2, internet space vs1, edmini_v2, D2 network version 1&2, raspberry Pi b
how to connect a serial cable to my 5big2
2 posts
• Page 1 of 1
how to connect a serial cable to my 5big2
by xuttux » Mon Aug 10, 2015 9:38 pm
You do not have the required permissions to view the files attached to this post.
- xuttux
- Posts: 4
- Joined: Mon Aug 10, 2015 8:06 am
Re: how to connect a serial cable to my 5big2
by Jocko » Tue Aug 11, 2015 12:45 pm
Hi xuttux,
There is no information about it on our site or nas-central.
As 2big2 is almost the same platform than 5big2 you can try to use this plugging schema : http://lacie.nas-central.org/wiki/Serial_port_%282Big_2%29
There is no information about it on our site or nas-central.
As 2big2 is almost the same platform than 5big2 you can try to use this plugging schema : http://lacie.nas-central.org/wiki/Serial_port_%282Big_2%29
- Jocko
- Site Admin - expert
- Posts: 11529
- Joined: Tue Apr 12, 2011 4:48 pm
- Location: Orleans, France
2 posts
• Page 1 of 1
Return to Lacie 5big Network vs2
Who is online
Users browsing this forum: No registered users and 9 guests