Lacie 5bign_v2 support

[fvdw]

ok I understand.
--edit fault in filename taken out

Then after firmware installation script is completed enter in the telnet client

Code: Select all

tftp -r UIMAGE-26394-NWSP2CL-106 -l UIMAGE-26394-NWSP2CL-106 -g ip-pc

replace ip-pc by actual ip address of your pc
Then write it to sda6

Code: Select all

 dd if=UIMAGE-26394-NWSP2CL-106 of=/dev/sda6

If thats done reboot

Code: Select all

reboot -f

and see if you can access the nas with fvdw-sl webinterface

[Draftmancorp]

...i'm coming...

[Draftmancorp]

have a problem:

when finish to instal 102, the telnet windows pop up, but it CAN'T CONNECT to lacie, connection timed out....

[fvdw]

Sometimes telnet react to quickly and kernel is not yet fully loaded and telnet not yet running
did you try then to connect by using the connect drop down menu of the telnet window, choosing the remote system tab and giving 192.168.1.252 as ip and click ok button

[Jocko]

Be careful, you mention in several post you use kernel 102.

Fvdw says you to use the kernel 106

[Draftmancorp]

nope. it wont work......

@Jocko.....yes, i have to do 102 before using telnet for use 106....the instruction was this.

[fvdw]

:mrgreen: I checked my notes, the standalone kernel is 101 (102 is not a standalone kernel)

sorry :whistle

[Draftmancorp]

tftp -r UMAGE-26394-NWSP2CL-106 -l UMAGE-26394-NWSP2CL-106 -g ip-pc

file not found.....but it is in the folder....

[Draftmancorp]

of course i used my ip.

[fvdw]

did you already install the firmware ?

writing the 106 kernel we will do after the script has run to install the firmware, follw the instructions mentioned in the fvdw-sl console for installing the firmware but do not close the telnet window when the installation script has finished only then perform the 106 kernel commands

in which folder is the 106 kernel ? it must be in the tftp directory of the fvdw-sl-console