Installing firmware on a new disk

[fvdw]

Because it doesn't start anymore my advise would be take out the hard disk and use the first install on nwsp2 procedure and files, in this case you don't need to partition the hard disk again in case it has already the partition table as described in the guide, in principle you only need to write the disk images to sdb1, sdb2 and sdb7 and write the kernel to sdb6 as described in the guide.
After that upgrade to 14-0

[shailesh]

Because it doesn't start anymore my advise would be take out the hard disk and use the first install on nwsp2 procedure and files, in this case you don't need to partition the hard disk again in case it has already the partition table as described in the guide, in principle you only need to write the disk images to sdb1, sdb2 and sdb7 and write the kernel to sdb6 as described in the guide.
After that upgrade to 14-0

FVDW, Kindly please split the file for the first install for nwsp2 first install
thanks in advance
shailesh

[fvdw]

its already done ;)

[shailesh]

its already done ;)

Thanks FVDW :)

[shailesh]

thanks FVDW and JOCKO, been able to install the NSP2 11 then installed the NSP2 - 14
working perfectly
and thanks again for youre work
regards n have a nice evening
shailesh

[fvdw]

thanks for your feedback :thumbup glad to hear that problems are solved now

BTW a nice location were you are....

[shailesh]

thanks for your feedback :thumbup glad to hear that problems are solved now

BTW a nice location were you are....

ya can say its a nice place to stay for holiday but for work its not good, else u too u are in a nice place :evilwink