I would like to increase speed of file transfer, according to this link,
http://www.jeffgeerling.com/blogs/jeff-geerling/getting-gigabit-networking
It's possible... I found Trendnet adapter and I connected it to my Rpi.
ifconfig results:
- Code: Select all
root@KrapotoMedia:/ # ifconfig
eth0 Link encap:Ethernet HWaddr B8:27:EB:FF:BF:43
inet addr:192.168.1.4 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:6116 errors:0 dropped:24 overruns:0 frame:0
TX packets:11 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:288379 (281.6 KiB) TX bytes:800 (800.0 B)
eth1 Link encap:Ethernet HWaddr D8:EB:97:B6:4C:91
inet addr:192.168.1.103 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:91004784 errors:0 dropped:2940 overruns:0 frame:0
TX packets:40816249 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3684318621 (3.4 GiB) TX bytes:3068364120 (2.8 GiB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:172 errors:0 dropped:0 overruns:0 frame:0
TX packets:172 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:13052 (12.7 KiB) TX bytes:13052 (12.7 KiB)
I tried to copy a file (1.5 Go) and the speed is around 16 Mb/s and sometime 20 Mb/s instead of 10 - 11 Mb/s before.
Do you think that is possible to configure eth1 to obtain better results?
Is it possible to disable eth0?
Thanks and best regards.