Hello,
I've just installed v16.0 and discovered a setting in FTP-Server: "Enable the 'Masquerade Address' option"
When I activate it, the server can't be started (error).
As far as I can tell this option writes the following lines into proftpd.conf
<IfModule mod_dynmasq.c>
# Refresh any configured MasqueradeAddress directives every 4 hours
DynMasqRefresh 14400
</IfModule>
and also the line
MasqueradeAddress
For the command "MasqueradeAddress" the parameter (e.g. a URL) is missing and there is no GUI-Field where I can enter this parameter.
Starting proftpd via commandline brings up an error telling this (see attachments).
Until now I have used the "Additional settings file" for this parameter but I would like to use the built-in settings.
How am I supposed to pass the URL-Parameter to the conf-file?
best regards
Mario