:fuming maybe still too big, a last trial with reducing the size kernel 26, if that doesn't run then there must be something else why the kernel won't run in standalone mode. To be honest it is very unlikely that it is the size of the kernel because this device has 128 MB of ram and a kernel may be 9extracted) 8 MB of size.
But try please this kernel 26 as last trial with small kernel
If it fails then I want to ask you to try again standalone kernel standalone 21.
But before setting up netconsole and uploading the kernel we do something different we are going to rest the ide interface of the board.
perform an ide reset command in the u-boot console- Code: Select all
marvell>> ide reset
I noticed that when loading the normal kernel form partition 6 we can see in your output of the serial console that this ide reset command is performed by u-boot before loading and booting the kernel !
We didn't do that uptill now with the trials of standalone kernel and this might be the reason why it won't load !
So i think it is worth a try
After reseting the ide (sata) interface in u-boot console proceed with the usual commands to set net console, upload the kernel and boot it (kernel 21)
If that won't work as well we need to go in the serial console mode to find the reason why the standalone kernel doesn't load.
ps tomorrow evening I might not be available due to a birthday party. but thursday i will be there again
You do not have the required permissions to view the files attached to this post.