I try 5 times now to manual install 15.1 firmware for NWSP1 from here with procedure described in howto file from archive downloaded from here http://plugout.net/viewtopic.php?f=7&t=1750&p=13448#p13448
On console procedure I noticed there is no kernel standalone for this NAS, for that reason I try to install manually, but I get nowhere doesn't get to connect to nas after writing firmware to hdd , how to check if procedure to writing firmware to hdd was OK, old hdd boot OK and I can connect to but new doesn't appear on network.
On router DHCP clients list doesn't appear also.
Regards.
I use no. of cylinders specific to 250 GB , last at 30401
I use an usb rack adapter for writing on HDD
I think I get it, in nas_conf_db.xml from partition no5 info regarded network without an IP and netmask is different from what I use, also info regarded to hdd is for a 500 GB made by Hitachi (what Lacie normally uses), if this my problem how do I modify that file to go with my setup ?
Where to look for signs on what is wrong ?