plugout.net

I made an error and now I understand why you was able to install the wrong firmware...

So do this in putty

Code: Select all

echo nwsp1 > /etc/platform

and try again to install the version 10.1 for nwsp1

Ok...i try...

Now 10.1 and....

login as: root
root@192.168.1.225's password:
root@nastest:/ # cat /etc/platform
nwsp1

:thumbup

...go with 15 version ??

:-D So seems nice but before post

Code: Select all

cat /boot.log

..ops....now 15.0 !!! :punk :hail

:thumbup :thumbup :thumbup :thumbup

Now I go to sleep Zzzzz......

Great job !! :applause

:applause Need to do 2 checks
Post the output of

Code: Select all

 uname -a

and

Code: Select all

cat /boot.log

login as: root
root@192.168.1.225's password:
root@nastest:/ # uname -a
Linux nastest.local 2.6.39.4 #5 PREEMPT Thu Jul 26 17:30:39 GMT+1 2012 armv5tel unknown unknown GNU/Linux
root@nastest:/ # cat /boot.log
start boot log
detect and set platform
nwsp1
UIMAGE-26394-NWSP1-5
nwsp1
update dev nodes
booting using sda2 root file system...
make dev node for buttons...
make dev node for tun device...
enable IP forwarding...
start buttons control daemon
device = nwsp1
source = buttons-phn
buttons-spd daemon started
Thu Nov 17 08:14:53 GMT+1 2011
create temporary passwd file
run udevstart to update dev nodes when necessary
inserting kernel modules:
configure loopback netwerk interface
setting reboot and standby
nwsp1
rebootd-phn
nwsp1
standbyd-phn
phn adapting motion.conf file
export reset gpio pin
starting php based setup routines step 1

* Found XML database configuration file... [ OK ]
* Updating Disks database... [ OK ]
* Configuring Disks... [ OK ]
* Starting mount of volumes...
- Mounting volume Default: [ OK ]
* Finishing mount of volumes... [ OK ]
* Generating Hosts File... [ OK ]
* Configuring System Hostname... [ OK ]
* Configuring Samba... [ OK ]
* Configuring LAN interface... [ OK ]
* Starting udevd... [ OK ]
* Starting web server... [ OK ]
* Initializing Timezone... [ OK ]
* Configuring Samba... [ OK ]
* Configuring System Users...
Root password: use default password
Set users, linux and samba accounts [ OK ]
* Starting syncawayd... [ OK ]
* Starting Fvdw-sl Discovery Daemon... [ OK ]
start portmap service
starting php based setup routines step 2
* Starting dropbear... [ OK ]
* Kill temporary dropbear... [ OK ]
starting php based setup routines step 3
* Starting daemon update Hosts File... [ OK ]
starting php based setup routines step banner


*** fvdw-sl NAS firmware
This is fvdw-sl version: fvdw-sl 15.0
built on: September 30 2013

LAN IP address: 192.168.1.225 (static)

Port configuration:

LAN -> eth0
php based setup routines finished
web permission on resolv.conf
set device tuning for dms performance
move smbd en nmbd db files to ramdisk to enable disk spin down
rcS finished
root@nastest:/ #

:evilwink

Hi almo65
So all seems right :applause
Now you can explorer all new features since version 5.1...

:bananadance

Thank's :applause