Hi,
I tried to install your firmware last night, and after realizing i needed to read the documentation it installed without a problem. I could see it when i went to the ip adres and set up a share and a network drive. Everything seemed to work as intended.
Then i wanted to add a disk, so i just shoved them all in, thinking the system would sort it out. It didn't, but then found the documentation related to that.
I tried to log in with putty, but thought i changed the password to something i can't remember when experimenting with the settings.
Then i decided i needed a fresh install, (i have since discovered that the pass was probably root:giveit2me) But i started from square zero and did the entire install process again on a fresh disk.
This time it went a lot easier. The entire install process went as before, everything fine, i reboot and i can't find it on the network.
Tried the assistant, it doesn't find an ip, tried an ip scanner, he doesn't find a thing either?
Any idea where i went wrong? I reinstalled everything like 5 times allready, and after the reboot i get a fast flashing red light on the front every time.