Time out with telnet ? any help

[Cricrou59]

Hi Jocko, how can I erase the other disks before I plug them into the NAS, because when I've done this I had some problems and Something had going wrong :
I think it had the original firmware on the disks and I must to begin once more time
Should I power off the Nas befor plugin the disks ?

[Jocko]

If you have lacie firmware on them you will have issue when the nas is booting.

So boot the nas with only the first disk and when boot sequence is ended, do an hot plug with the other disks

Wait few seconds and then go to the disk setup menu. When you will ask to init disks, you should see them in the 2d table "Other disk detected by the firmware"

[Cricrou59]

Jocko can U give me the command to initialize the disk because when I plug the disk I'm losting the connection with the web interface, otherwise I can format the disk but I have to take an external enclosure to do this

[Jocko]

So the easy way is to format your disks with your laptop ( you can use any format type) and reboot the nas with the reset disks

[Cricrou59]

I've formatted the disks with my laptop but when I plug all of them with the NAS powered on I'm losting the connection with the web interface.
Are the disks too big for the NAS, originaly there was of 1.5 to ? Now the led of the NAS is blinking red and I'm using 5 disks of 2to WD Red

[Jocko]

You did not make what I asked you

nd reboot the nas with the reset disks

So not a hotplug.

if it failed again maybe you have an issue with power supply

Now I am no longer here. So see you later

[Cricrou59]

Jocko, there is something going wrong in the method to put the other disks, when I reboot the Nas with them after a while the led of the Nas is blinking red and I have to reinstall the firmlware.
So I have to make a Uboot command with Ide Reset, but I have to launch Uboot and to wait a while before sending ide reset command for The Nas recognize the disks. And then I can install the firmware on the first disk only (left viewed on the back side)
Sorry but I don't manage to issue well

[Cricrou59]

I'm back home after work and now I don't issue with Ide Reset for initializing disks !!!

[Cricrou59]

Hi I think the disks are not spin out with ide reset command but I' m not sure because I don't hear anything in the Nas, certains leds in rear are blinking red but that's all.

[Cricrou59]

Re,

I've send the command ide reset many times and only the first disk is spinning out with a little click, the led of the disk is blinking red too. Now I'm blocked because I can't initalize the disks, I don't know what to do next ....