Hi,
I need some help. I've been trying to troubleshoot this for four hours....
OK, so completely blank hard disks in the 2Big Network V1 NAS, ergo no firmware. Drives were DBANed. Didn't realise the Lacie firmware was on the drives, anyway....
In a nutshell, in fvdw-sl console I select the UIMAGE file, I've chosen both (separate attempts) 1.1.1 and 1.1.4, the command window appears showing "waiting for uboot"
UIMAGE-26394-2BIG1-27-1-1-1-standalone
UIMAGE-26394-2BIG1-47-1-1-4-standalone
I turn on the NAS...
"waiting for uboot" just stays there and doesn't install the firmware.
So 1. Is it that in the console "IP address for NAS" is the IP that has already been set up the NAS? But how can I set the IP address of the NAS without firmware on the NAS to allow me to set the IP address? It's chicken and egg.....
or 2. Does the install process just listen for a polling packet and once the firmware is installed, the NAS IP address set in the console is the static one for the NAS that telnet then automatically connects to?
The NAS hardware was fine. Drive 1 spins up, drive 2 spins up. Of course it finds no firmware then the drives spin down and the network port blinks as normal.
Where am I going wrong?
Thanks