Re: NAS doesn't boot after setup Raid
Posted: Wed Feb 01, 2017 10:54 pm
Jocko wrote:Hi jungfichte,
It is fvdw who is the expert for uboot. What you can do and I think he also go to ask you to try :
Stil from a uboot window, do(bootm should load the kernel on sda6...)
- Code: Select all
version
ide reset
ide info
bootm
So post all these output
almost good,
- Code: Select all
ide reset
run boot_disk1
only if the last command loads a kernel do
- Code: Select all
bootm 0x400000
If this works than the problem is that the lump value is preventing the normal boot. This could have to do with the position of the switch on the back of the 2big1. At which position is it ? safe100 or big ?
A forgot in which position it must be. Just switch it to the other position and try if it boots