I have a 2big Network v2, motherboard 2big-NAS-KW, 0901 750 Rev B.
No modifications, the firmware was initial LaCie (as I can not access it anymore I do not have more info about it, but it was updated to the latest I guess)
There are no more HDD-s in it, as first failed one of them...of course the RAID failed then too...but I did not changed it, worked with the remaining one, but after a while that failed too.
The problem is that I can't access the device anymore.
It is connected to the network, no sign of anything on the network looked on the routers log...ARP for his MAC ...nothing
(the bottom LED on its network card is steady green, the top one shows rapid blinks ). I have the USB plugged in, no sign on the machine that it is connected at all. However, the front led is blue, the two rear leds are red (there are no hard drives connected). If I plug in the HDD that failed last, it at least spins it up, and the LED on the appropriate side turns blue. But no change whatsoever.
I did a factory reset: front switch pressed and kept that way ->, rear power on ->, front LED red-blue alternating light ->, -> then turns constant red on, -> button released, -> a few blue flashes, -> then constant blue on, -> now button pressed once, -> some blue flashes, -> few seconds and then constant blue on. I guess the factory reset process and reboot done.
Btw the cooling fan is dead, so it's not plugged in at all, but it shows no sign that it matters at all (maybe because the temperature doesn't even justify a signal...). Despite being dead, I tried while plugged in too, but no change, but not even the manual mention that it would have an effect on the behavior.
Any clues?
Thanks.