Blue LED Blinking and no network access to 2Big Network

[PaaNooS]

Aaaa no no. I've just pull out second disk.
RAID is working perfect

[Jocko]

ok :thumbup

[PaaNooS]

So I have to thank you Jocko and fvdw for the whole support.
You are the best ! :applause and just donate ##€
Thanks again
Bye :corner

[PaaNooS]

Hi

today I tried to backup one of my PCs. I use to do that with GoodSync application
I mentioned that my NAS was stuck after a while. I couldn't access him with windows explorer neither with web browser.
I had to power off and on so to can access him.
I think I had this problem a long time ago and if I am right problem was Jumbo Frame. The right setup was OFF (1500).
Now with 'fvdw' firmware I cannot see any this setting

[fvdw]

The ethernet driver use standard MTU size (1500 bytes).You could use ifconfig command to change it but after reboot you will have to set it again. You could use a cron task for that. But I recommend not to use jumbo frame size, first because they will not speed up transfer and the reliability of ethernet traffic is affected.

PS I recently transferred 700 GB of data to 2bignas using rsync without any issue. I have no experience with the backup program you mentioned.

[PaaNooS]

Look.
My computer has 2 hard disks. Disk 'C' has operating system (Windows 7) and disk 'D' contains my documents (.doc, .xls, .pdf, .cdr, .dwg, jpg, .tif etc files)
First I tried to backup my documents (disk 'D'). Everything was ok and backup ended without any problem.
So after that I tried to backup disk 'C'. The way that 'goodsync' works is like that : First analyses (reads) source and destination disks and compares them, then creates new folders to destination disk and at last copy one-by-one file from source (disk 'C') to destination (NAS).
So during creation new folders my NAS stuck 2-3 minutes from beginning. I thought that was by mistake. Restart my computer and my NAS and tried again but after creating about 10-15 folders stuck again.
After that I tried with another windows computer but had the same problem.
I use goodsync for at least 10 years to backup my 5 windows computers to 3 NAS (2 WD myCloud and 1 Lacie 2big) without any problem so I'm afraid that something goes wrong with new firmware

[fvdw]

This looks similar as the way total commander works. I use that frequently to synchronize directories on pc and nas. I never experienced issues that you describe. Because I can not reproduce your issue it is impossible to find out what the cause is. I will try to get goodsync trial and do some tests.
Question did you upgrade samba to version 4?

[Jocko]

Hi

As goodsync handles several exchange protocol, what protocol did you use ?

[PaaNooS]

Question did you upgrade samba to version 4?

No. Just installed fvdw firmware, update to 18.2 and install 18.2 patch. How can I upgrade samba??

[Jocko]

Yes you can. So you made a backup via smb protocol ? and surely better in this case to use samba4 version instead of samba3 because you may use smb2 or smb3 protocol. With samba3 only smb1 protocol is available.