Page 1 of 1

Fresh install looking for samba 4.0

PostPosted: Wed Feb 16, 2022 10:38 am
by lwijns
Hi!

I just installed the firmware on my old Lacie network disk and would like to use samba 4.0. That's why I made a donation using paypal. Can you add me to the contributors list so I can make use of the feature?

Thanks!

Re: Fresh install looking for samba 4.0

PostPosted: Wed Feb 16, 2022 11:28 am
by fvdw
Done
Thank you for your donation, much appreciated.

Re: Fresh install looking for samba 4.0

PostPosted: Thu Feb 17, 2022 4:45 pm
by lwijns
Thanks!

I also have some problems with getting the external USB working. currently when connecting with putty and entering lsusb -t i get the following:
/: Bus 01.Port 1: Dev 1, Class=root_hub, Driver=orion-ehci/1p, 480M

Could you help me get the external usb working? I have a usb drive connected formatted in exfat.

Re: Fresh install looking for samba 4.0

PostPosted: Thu Feb 17, 2022 8:35 pm
by fvdw
Which kernel are you using? If it is 4.14.133-1 then this a known issue caused by missing code in kernel setup to enable usb power.

I assume you use fvdw-sl-18-1 or 18-2. In that case you should have above mentioned kernel.
Attached a patched kernel (extract the zip file).
You can test by using fvdw-sl console and using the feature load and start external kernel.
To do that put the file in the tftp folder of the fvdw-sl console switch of your nas and start fvdw-sl console and select appropiate action

If you are happy with it you can install on your firmware disk
Put the (extracted) file in the schared folder fvdw
Connent via ssh to your nas
change to fvdw folder
Code: Select all
cd /direct-usb/fvdw

write the kernel to the correct partition.
CAUTION !! be sure that you write the kernel to /dev/sda6
(using wrong partition will make you nas firmware non functional or destroy your data stored on your nas)
Code: Select all
dd if=UIMAGE-414133-KIRKWOOD-2 of=/dev/sda6

Now the new kernel will be loaded at next boot

Re: Fresh install looking for samba 4.0

PostPosted: Sun Apr 14, 2024 10:30 pm
by jrosasdominguez
Hi,

I am also looking for samba 4.0 for a 2Big NAS. when i tried to switch the version it just rolls back to older version

Thanks,

Re: Fresh install looking for samba 4.0

PostPosted: Mon Apr 15, 2024 8:05 am
by fvdw
Hi you need to be donator to get samba 4. We received your donation and added you to to donators group so you should be able to install it

Re: Fresh install looking for samba 4.0

PostPosted: Mon Apr 22, 2024 4:44 pm
by abianchi
Hello, sorry to hijack the topic but i'm here for the same reason: could you please add me (recent donator)?
Thank you and kind regards