2BIG2 not detected after upgrading

[alfa76]

I have the same problem, the upgrade go well. But after the reboot of the nas I dont see it on the network. Any suggestion ?

[Jocko]

Hi

I created a new topic...(Please to use your own topic)

Your nas is not detected after the first installation or after upgrading the firmware ?
(in the topic where you posted it was after a first installation and not after upgrading as you wrote)

[alfa76]

After the first installation, I used the firmware 18.0.

[Jocko]

Ok

So it is an issue on the first install.

Do you have a dhcp server available on your LAN (should be available via your router) ?

if you use fvdw-sl assistant, this one detects it ?

[alfa76]

Yes, the dhcp is active on the router and I tried to find the NAS by fvdw-sl assistant and also I tried on the network map but nothing. The only thing is that the router was configured to .239 and the subnet is 192.168.104.*

[Jocko]

The only thing is that the router was configured to .239 and the subnet is 192.168.104.*

This is not an issue.

A basic point, do you keep the 2d disk in its slot (right disk when you see the disk slots) whereas it still contains lacie files ? if yes you should try to restart the nas without it and see what happens

[alfa76]

If I keep only the left disk, the lacie firmware start and I see the NAS. If I keep the right disk, I don't see nothing

[Jocko]

well. It is the expected behaviour
It is clearly warned in the fvdw-sl console topic

-If you have a multi disk nas and use the fvdw-sl console and standalone kernel install only 1 disk in the nas in slot 1 (most lefthand slot seen from back) to prepare the system disk.

Now you have two ways to initialize the 2d disk:
- plug the 2d disk on a laptop and remove all partitions on it and then you will be able to start the nas with both disks
- start the nas with only the left disk and then do an hot-plug with the 2d

Then use the web-interface : load the disk setup menu; click on the button "Initialize hard disks and volume", sdb should be listed either on the first or second table, select sdb disk and submit it

[alfa76]

I tried to remove the right hand disk, repeat the installation proceduce using fvdw-sl-console, but when I reboot the nas nothing. I tried also to hot plug the second disk, but again nothing. Some other suggestion ? Thx for you support

[Jocko]

So we need to investigate sda (it is the system disk with our firmware)

So use again fvdw-sl console but this time select as action "Standalone, load and start". Like previously you have to select as kernel, the standalone kernel image for kirkwood (UIMAGE-3142-KIRKWOOD-171-standalone).

When you get the console, run these outputs

Code: Select all

gdisk -l /dev/sda
mkdir /sda7 /sda5
mount /dev/sda7 /sda7
mount /dev/sda5 /sda5
ls -l /sda7
ls -l /sda5
cat /sda7/boot.log
cat /sda5/installer.log

Please to post the output of these commands