ok here are the instructions
Nas switched off.
In de fvdw-sl console choose action start tftp server after that choose action "uboot console". (Nas switched off)
Start nas when console mentions waiting for uboot.
Can take some time before you get message in uboot console window to press enter to get uboot console
When that happens click on the window and press enter, you should get a prompt line this
- Code: Select all
marvell>>
In this u-boot console window give these commands
- Code: Select all
setenv bootargs console=ttyS0,115200 netconsole=6666@${ipaddr}/,6666@${serverip}/ root=/dev/sda7
use the commands exactly as they are given so do not replace the parameters ipaddr and serverip leave them as they are in this command
PS the u-boot console window has a paste option (right click on title bar)
check if now bootargs parameter is set to this string
- Code: Select all
printenv bootargs
If they are as set previously proceed with commands
- Code: Select all
ide reset
wait till completed
Then enter
- Code: Select all
tftpboot 0x800000 firmware/kirkwood/UIMAGE-414133-KIRKWOOD-1
you should see the kernel being uploaded.
When done give command
- Code: Select all
bootm
You should see in the u-boot window that the kernel is started
If the kernel loads it should show you after mentioning starting kernel detailed output of kernel in the u-boot console window. If the kernel fails before netconsole is activated in the kernel then there will be no output.
It can take some time before the output comes. Try to copy the output by using the edit option of the console window, click with right mouse button on titlebar of the uboot console window, choose "mark" mark everthing by scrolling up and down, then choose "copy" and paste it in a new file on your pc.
In the attachment the output as I get it on my 5big2.
You do not have the required permissions to view the files attached to this post.