Blue LED Blinking and no access to 5Big Network v2
Posted: Wed Oct 26, 2016 9:32 pmHi,
I am new to this forum and I will need some help please to see if I can fix my 5Big Network 2 NAS.
The NAS worked perfectly until I decided to do a change in Network Settings, moving from bonding LANs to only one LAN interface. After the restart, I've got an error saying "Your device may be powering on. Please try again in a few minutes." I restart it and for the last weeks is still saying the same error. After a few searcheas I found that the firware might be corupted and needs to be reflashed.
The NAS is getting an IP but I cannot get into the Lacie Dashboard. I have 5 X 1TB HDD and I dont care if I am loosing the data as I have another NAS where I was keeping the Lacie backups. I did try to do a factory reset but the NAS is blinking continously blue and the reset has not been done succesfuly.
Please I will need some guidance on how I can fix this issue and restore the Lacie firmware.
Thank you in advance.
Patrick
I am new to this forum and I will need some help please to see if I can fix my 5Big Network 2 NAS.
The NAS worked perfectly until I decided to do a change in Network Settings, moving from bonding LANs to only one LAN interface. After the restart, I've got an error saying "Your device may be powering on. Please try again in a few minutes." I restart it and for the last weeks is still saying the same error. After a few searcheas I found that the firware might be corupted and needs to be reflashed.
The NAS is getting an IP but I cannot get into the Lacie Dashboard. I have 5 X 1TB HDD and I dont care if I am loosing the data as I have another NAS where I was keeping the Lacie backups. I did try to do a factory reset but the NAS is blinking continously blue and the reset has not been done succesfuly.
Please I will need some guidance on how I can fix this issue and restore the Lacie firmware.
Thank you in advance.
Patrick